Pod type air filter for increased air flow

Made from a high performance twin layer foam this K & N type air filter is designed to offer improved and unrestricted airflow whilst offering adequate filtration. Washable and reusable (use hot soapy water). Best run dry for road. Fits VHB 29, VHB 30, PHBH28 and PHBH30 Dellorto carbs. You may find that a 5-10% increase in main jet size helps to make the most of the increased air flow with this filter

 This part is available by special order, request a quote

HIgh performance aluminium velocity stack for airbox to throttle body union on single throttle body models. This velocity stack replaces the standard part with an aluminium part that protrudes into the airbox. Through careful design it improves the engine response by providing an increased volume of less turbulent air to the throttle body. No modifications are required to fit this velocity stack but you should see a torque increase of around 6% at 2500 RPM and 3% increase in power at 6500 RPM

This manifold is suitable for EURO 4 and 5 models, manufactured on the shores of Lake Como. Developed for optimum power and torque on Mistral's rolling road. For best results combine with a performance air filter - SIA10434.

Simple to fit, installation time is less than 30 minutes and the battery does not need to be disconnected.

 This part is available by special order, request a quote

Fuel injector

Genuine Marelli part

 Order now and we will post your order within 7 days.

 32115710 GU32115710 32 11 57 10
 3211 5710 3211.5710 32.11.57.10

Lid for airbox, air filter sits inside this

Also known as Guzzi ref 23113760

 Sorry, this part is no longer available.

 19113760 GU19113760 19 11 37 60
 1911 3760 1911.3760 19.11.37.60

Lower choke cable, fits both carbs

Two cables required. We advise you to measure your existing cable before ordering in case you have a non standard set up.

 This part is due back in stock soon, call 01484 841395 to reserve yours

 27133515 GU27133515 27 13 35 15
 2713 3515 2713.3515 27.13.35.15

This adjustable fuelling modifier uses the lambda sensor signal to the ECU. By modifying that signal it achieves an improvement in low and midrange throttle response. Comes with wiring harness and instruction manual, installation is simple and does not require any specialist tools. Suitable for all single throttle body V7, V9 and V85 TT models.

Rapid Bike EASY: A base level simple plug and play modulator equipped with a microprocessor managing the lambda sensor signal to optimize the air/fuel ratio, improve the engine efficiency and eliminate power gaps typical of the low and medium rpm range.

See installation instructions here.

 This part is available by special order, request a quote